More Gift Card Holders

Last week I mentioned that I had a few birthdays coming up and that I would need some gift card holders.  I made small ones but the gift cards I purchased were attached to cardboard so I had to go back to the drawing board.  Here’s one I made for my sister using my Envelope Punch Board and a piece of yummy Cucumber Crush from the 2015-2017 In Color Designer Series Paper Stack.

Gift Card Holder Cucumber Crush

Gift Card Holder Inside CC

And one for my brother-in-law using Smoky Slate from the Neutrals Designer Series Paper Stack.

Gift Card Holder Smoky Slate

Quick Tip:  I used the stamp set, Remembering Your Birthday, for the gift card holder above.  In the picture below, you can see the stamp I used in the lower right hand corner.  I only wanted Happy Birthday, not “friends and fun and presents too” so I just inked up Happy Birthday.  Usually when I do this, I have to cover the words I don’t want with a post it before I ink it, but the words are spaced far enough apart that it wasn’t necessary.  More mileage out of your stamp sets!

Remembering Your Birthday

 

You can see this same style gift card holder from a previous post here.

(Note:  After writing and publishing this post, I took a shower – I do my BEST thinking in the shower.  Anyway, it dawned on me that the gift card in the previous post that I mention above is not the same as the one in this post.  I had to make adjustments for the larger size of the gift card.  My paper size was 8-1/4″ x 8-1/4″ and I did my first score and punch at 3-3/8.)

Thanks for stopping by today!

Product List – Click on any item below for more information or to place an order.

Leave a Reply